Pioneer holiday timing issue?

[stonykill]

I have a few pioneer Holidays I am fooling with. I got one to run and it won't rev, occasionally trys to rev, but won't. It idles fine. Compression is 115 lbs cold, 3 pulls, a little low I know, but I have run plenty of others at this compression. It reminds me of my old chevys when the timing was off. Almost forgot, I believe this has an aftermarket electronic ignition on it, my other 2 saws don't have that box by the coil, but then again they don't run. Any help would be appreciated. thanks>>Tom:rockn:

 

[PES+]

What does it do when it trys to rev?

 

[PES+]

Is it a single terminal module or a two terminal?

If it an atom module what color is the plastic case?

 

[stonykill]

What does it do when it trys to rev?

it momenterily revs, for about a 1/2 a second or so then right back to the struggle to rev. It also spits some raw gas out the carb while doing this.

 

[stonykill]

Is it a single terminal module or a two terminal?

If it an atom module what color is the plastic case?

Its a 2 terminal module. It appears to be an aluminum ,module, has 6105 stamped on the side. :rockn:

 

[PES+]

Check all your module connections make sure all are tight you can slightly tighten the spade lugs by carefully closing them with some small pliers when all connections are tight you can try reversing the two leads on the module

 

[stonykill]

Check all your module connections make sure all are tight you can slightly tighten the spade lugs by carefully closing them with some small pliers when all connections are tight you can try reversing the two leads on the module

I was going to try that, but I wasn't sure if I would fry something by reversing the terminals. I'll try that tomorrow. thanks>Tom:rockn: