Pioneer id

[camel2019]

So I got this is a bunch of parts saws still has a decent jug and piston both the 2200 and 1200 recoil I have fit

 

[camel2019]

I'm guessing Holliday? Want to build it into a firewood saw since it's a little Frankenstein already idc what it looks like

 

[Jasonrkba]

Holiday. Here is mine. SXL rings fit. I forget what seals to use, I have a thread somewhere. They are loud saws. Slow and grunty.

 

[camel2019]

Holiday. Here is mine. SXL rings fit. I forget what seals to use, I have a thread somewhere. They are loud saws. Slow and grunty.

Good that works I'm going to pull it down and check the bearings and crank ect thinking about putting a round filter on it with som sort of adapter and maybe make a muffler idk. will need to find other stuff for it like the bar plates and cover the clutch bell is a little worse for wear and will need a top handle/mount idk if I have one somewhere. It would be one of those saws where I wouldn't care how it looked just as long as it functions kind of a bone yard parts deal.

 

[Jasonrkba]

We call that a turd saw and sometimes they run great. It has a wick fuel filter and if you are splitting the case i would replace it at that time. Some gaskets are still available.

 

[camel2019]

We call that a turd saw and sometimes they run great. It has a wick fuel filter and if you are splitting the case i would replace it at that time. Some gaskets are still available.

Yeah going to need that and a gas cap hopefully I can find the filter cap shouldn't be too hard I may even have it somewhere the bot everything was in kinda fell apart after sitting for 3 or so years.

 

[Jasonrkba]

Ebay and chainsawer.com has everything.

 

[camel2019]

I also discovered I have either a p series or a 1074 shell sitting here with the points so hopefully I can figure out my 1074 it wont shut off

 

[camel2019]

Is the homelite super xl the same saw? Sure looks like it. Looking at the jugs and a few other parts as well as the shape of the saw ect.

 

[camel2019]

Well my parts saw showed up and other then scoring on the piston on the exhaust side it looked decent was definitely ran a lot has everything I need missing a few screws but I think we all are.
Difference between this one and the other hull is this one has a choke carb(my original has the primer ball)and a rim sprocket clutch idk what one to build yet will have to tear them down and have a look.
Between the 2 there’s enough parts to build a saw.

 

[camel2019]

I’m wanting to use a clamp on style air filter on this old girl I’m thinking one of the foam ones. Red beard saws says the air filter adapter from a Husqvarna 281 288 low top will work on some pioneers anyone got any ideas?

 

[camel2019]

Is this useable has something like putting in the cylinder and this was supposed to be the good cylinder.

 

[camel2019]

There’s a few of them all the way around the cylinder and they go through the plating

 

[camel2019]

Anyone have a homelite super xl cylinder laying around that they could measure for me?