Porting The MS201T

[angelo c]

Are we talking about 201TC or 201t. The electronic saws and the solenoid issues changes the game on "repair" .

 

[Trial-n-error]

So......I setup the jug in the lathe and cut .006" from the squish band, and made the clearance .016" without a base gasket. That will bump the compression about 25psi.

You know your degrees of your intake and exhaust? I need some guidance. Right now with base gasket mine is 150 in. 146 exhaust.

 

[Joshcnly]

I can't tell that the new ones are much better than the old ones Doug.

I think they may be tuned a little better from the factory now though. Proper tune makes a huge difference in this unit.

Can you tell me what sealant to use on the tranfers covers it looks like you opened them up

 

[pioneerguy600]

Can you tell me what sealant to use on the tranfers covers it looks like you opened them up

You will not get a response from the member you asked the question of.

 

[Joshcnly]

You will not get a response from the member you asked the question of.

Darn okay thanks for the heads up