Poulenc wild thing 2375 lol

[Jkstihl]

Any interest in this?
Needs fuel lines and bulb
Runs with a squirt of fuel down carb. I have no interest in it but I know there are some wild thing fans out there. Don’t really know how much to ask for it so make me a offer.

 

[jp233]

heck, that looks pretty decent unless it was a total mess before and you cleaned it. throw some lines and a bulb in it, few bucks, the bar looks barely used but obviously not original. Buzzy little saw. around here those go for about 30-40 bux if they aren't fully running and good to go

 

[RED-85-Z51]

Probably not worth the cost of shipping. I like mine, bury the 18" bar and let your hands turn to jello but they run hard.

Sent from my LM-G820 using Tapatalk

 

[Justin Taylor]

The bar is worth more than the saw but it would take you less than 10 minutes and 2 feet of fuel line to fix it

 

[redunshee]

Probably not worth the cost of shipping. I like mine, bury the 18" bar and let your hands turn to jello but they run hard.

Sent from my LM-G820 using Tapatalk

yup. Had one that cut very well. knda tough on the hands with the vibration. Otherwise , not a bad saw. Prefer it to the 4018 series which are strato saws.

 

[Natster]

Any interest in this?
Don’t really know how much to ask for it so make me a offer.View attachment 838446
Ok, I hereby offer you the following. Go put that saw under your neighbors (that you hate) carport. Then, wash your hands.
Be sure and put a note that says:
I hate this saw. Have a nice day!
Sign your name.
You may wind up friends with this neighbor, as you will now have a common enemy!
(Where's the smirk icon)

 

[cranman1951]

Free up to $20 not running.....$50 to $75 running. Nice little saws but not worth putting time and money into. I kind of like tinkering with the Poulan Pro saws....can sometimes get $100 for one....

 

[jrs_diesel]

FWIW they are fun saws to tinker with, and simple to work on. The lack of A/V stinks, especially if you run one for a length of time. Other than the A/V, they are decent performers, even better with a MM.

Where in Alabama are you? I'm kinda close over here in Louisiana so I have some interest in it if you don't want it and are on the southwestern side of Alabama.

Is it saw only, or saw and case?

 

[OM617YOTA]

I ran the Craftsman version with A/V for a couple years. I wouldn't buy one now, but when I had it, it did what I needed it to do and I was thankful to have it. These days my battery electric has taken over anything I'd use that for.

 

[RED-85-Z51]

If mine had av it would basically be a husky 142

Sent from my LM-G820 using Tapatalk

 

[Jkstihl]

FWIW they are fun saws to tinker with, and simple to work on. The lack of A/V stinks, especially if you run one for a length of time. Other than the A/V, they are decent performers, even better with a MM.

Where in Alabama are you? I'm kinda close over here in Louisiana so I have some interest in it if you don't want it and are on the southwestern side of Alabama.

Is it saw only, or saw and case?

North bama, I don’t mind shipping. But I’d have to get $50 shipped to make it worth my time. Top rated seller on eBay I have it listed on there, but I don’t mind selling straight thru PayPal.