Want to Buy Remington Roller Nose Tip

[ML12]

I've recently acquired 2 NOS (one still has the dealer decal on it) Remington bars but they don't have tips on them. I am looking for a roller tip for these bars. I believe they need the 2.5" diameter roller.

Here is a photo of the slot in the end of the bar:


The roller tip doesn't have to be new as it will likely not see too much use.

Let me know what you have!

 

[RenaisSAWnceMan]

I have two REM rollers (bars).... Will check 'em later.

I'll provide the critical measurements, so you can confirm fitment, and pirate the rollers iffin they are correct.

 

[RenaisSAWnceMan]

ONE of the two I have, has a 2.5" DIA roller....but, it has a measured 1/32" of play; doesn't sound like much, but it moves enough that it will presumably drift under load, and even with none...
Though, may be adequate for your stated purpose...

The tongue is 1 4/3" across; rivets are about 13/16" x 9/16" on-centers.

The tongue is right about 2", from inner point to bar bitter-end. Note that your bar has provision for just the one
set of rivets, and...the insert depth/distance does appear to be less.

If you can use it, I spose I can pop it off, and send her....unless you want the bar as well.

 

[67L36Driver]

Holes on the bar arn’t for rivets. For the detent dimples on the roller nose.

They just snap in/out.

 

[RenaisSAWnceMan]

Ahhhh see..... Never had occasion to fuss with one. Thanks.