SkyWorker 1945A

[mrautocar]

Hi, Could some one help with info on my skyworker boom, Im having control valve issues, most likely air in the system, I would like to know where to get parts and manuals for this and also whts the easy way to change to high pressure controls, THank you

 

[tomtrees58]

man they out four 30 years now tom trees

 

[CentaurG2]

I think Skyworker was taken over by Aerial Lift of Conn. They might be able to help you locate some parts or manuals. Usually, the low pressure system works fine unless you have a leak, bubbles in the oil or some vermin overwintering in your booms ate through your lines. Our old lift had a hand pump and a small oil reservoir in the bucket. You just gave it a couple of pumps (like an old coleman lantern) and she was good to go. I doubt conversion to a high pressure system would be feasible on an older lift. If all else fails you can try RGB in Raymond NH. They are pricy but can probably get you what you need. Good Luck. www.raymondbucketguys.com/default.htm