Solo 644

[buzz sawyer]

Any chance the coil from a 667 will fit a 644?

 

[StihlSolo]

Maybe no, maybe yes. See photos of my 662 and 644 (apologies for the blurred photos). The 662 and 667 are supposed to be same chassis. So if they are, the 662-667 coil mounts & screws in my saw are in different locations than in my 644 (that's in the middle of a rebuild).

But, also see also the IPL pages. The 662-667 IPL shows a different coil with different screw locations, but unfortunately this IPL does not show any mounts in the crankcase side. Figure Solo had different versions.

 

[buzz sawyer]

Maybe no, maybe yes. See photos of my 662 and 644 (apologies for the blurred photos). The 662 and 667 are supposed to be same chassis. So if they are, the 662-667 coil mounts & screws in my saw are in different locations than in my 644 (that's in the middle of a rebuild).

But, also see also the IPL pages. The 662-667 IPL shows a different coil with different screw locations, but unfortunately this IPL does not show any mounts in the crankcase side. Figure Solo had different versions.
View attachment 908916View attachment 908917View attachment 908918View attachment 908919View attachment 908920View attachment 908921

Thanks, thought it might not. This thing starts cold and runs fine until you shut it off and wait a few minutes, then won't start. After a couple dozen pulls, it fires up but doesn't smoke like it was flooded. Will get into the carb next.