Want to Buy Stihl 011 Case gasket

[jggrmson]

Im looking for this 011 case gasket. Dealer says they cant get it.

 

[morningman]

Still looking?

 

[jggrmson]

Not unless you have the flywheel and clutch seals as well dealer wanted too much for 2 gaskets and 2 seals.

 

[morningman]

I will dig tonight

 

[nstueve]

you need a couple standard oil seals and a case gasket???

Clutch side is 13x21x4 (9640 003 1330) http://www.partzilla.com/parts/detail/honda/HP-91212-MN5-003.html
Flywheel side is 13x19x4 (9640 003 1320) http://northwoodsaw.com/store/index.php?l=product_detail&p=895

As for the gasket... cut one by hand from a sheet of material if you're looking to go cheap. You can buy sheets of gasket material from your local auto parts store.

 

[jggrmson]

Thanks nstueve.

 

[nstueve]

Thanks nstueve.

Make sure to clean the case halves really well where they mate and I usually use a little high heat rtv or yamabond or hondabond to help close up any imperfections. Also when you are adding the bearings back onto the drive shaft I suggest using axle grease to help hold them on while you put them all on and slip the connecting rod over them. It's a huge PITA if you don't. The gas mix will melt off the bearing grease and burn it off in the first few tanks so don't be alarmed when your saw smokes for the first tank or two...

 

[nstueve]

PS: if you are cutting your own gaskets it's pretty nice to have a cheap set of hollow hole punches around. And take it from me... You want to practice using them before you cut 90% of your gasket and then tear it up using the hole punch...