Stihl 011???

[rahtreelimbs]

I have an older ( all orange) Stihl 011 that I am worjking on. The saw needs a new bar. I have one for an 009 thru 025. This new bar has the oiler hole separate from the bar adjustment pin. The original bar oiled through the opposing adjustment pin hole. When you put the new bar on the 011 you can see that the small separate hole is a little exposed. Will this bar work? The bar sleeve says that it will work on an 011, but this oiler hole has me baffled.

 

[Stumper]

When you put the new bar on the 011 you can see that the small separate hole is a little exposed.

Exposed in what way Rich?

 

[rahtreelimbs]

Exposed in what way Rich?

The smaller hole is slightly above the boss that the bar mounts on. I think this would be a no-brainer to leak oil, but here again the bar sleeve says that it is for an 011. Did they make a change on the 011 at some point in time?