Well, I thought I had the 288 running but it is still a no go.
The saw will run good after cranking and then warming up but when you shut it down it will not start back up and has a wet plug.
I was trying to adjust the high needle this afternoon and noticed that when you adjust the hi needle out it wouldn't 4 stroke or lean out so I am guessing I have a bad Hi jet screw. The low jet screw works great. I looked up the kits at bailey's and they don't come with the jet screw.
Do you guy's think this could be the problem? If so where can I find a kit that comes with the jet screws?
The saw will run good after cranking and then warming up but when you shut it down it will not start back up and has a wet plug.
I was trying to adjust the high needle this afternoon and noticed that when you adjust the hi needle out it wouldn't 4 stroke or lean out so I am guessing I have a bad Hi jet screw. The low jet screw works great. I looked up the kits at bailey's and they don't come with the jet screw.
Do you guy's think this could be the problem? If so where can I find a kit that comes with the jet screws?