It is on the 10-10 right now, but after getting the saw in running condition, I think I need to put new crank seals in it, it is spitting out the intake tad, and does not want to tune right, acting slow on the throttle response and not a lot of power, like it is sucking air from somewhere other than the carb.
The mounting on the PM700 will be exactly the same as this is depicted, as the saws look almost identical from the outside, and dimensions and bar studs are the same.
view looking at the bottom plate, showing 5/16x24 3/4" long bolts, 5/16 washers and the coupling nuts underneath (see next pic).
pic showing the coupling nuts installed, holding the bar and side cover on, I used 2 thick washers under the coupling nuts next to the bar cover, and 2 washers between the nuts and the timberjig mounting plate, then 2 more washers under the heads of the bolts, so, 2 nuts 2 bolts and 6 washers, total hardware count.
pic of it mounted and resting on the rollers. Still havent got to using it yet, will be toward the end of the week. i will post again when I have had an opportunity to use it. I think it will work very well.
