vintage oleomac / olympic 264F deluxe

[Siloopy]

Hi there I am rebuilding an old 264f deluxe and I am looking a bar (~ 20in 72dl 3/8 0.58) for it.
The bar mount of the 264f deluxe is D024 (10mm) and it is impossible to find this type of bar in UK.
I am thinking to either:
- buy a D009 bar and I can file down a bit the bar studs on the chainsaw (permanent conversion to D009) (my preferred route)
- buy a D025 bar (can find some but not many choice here) and use/make an adapter.

What do you think?
Thanks
Siloopy

 

[RedneckChainsawRepair]

Info from here. https://www.acresinternet.com/cscc.nsf/BMP/18?OpenDocument . Double check it as not always correct info there. But might help look for other bar makers.

https://www.greenacresmowers.com.au/chainsaw-bar-prokut-20-x-3-8-x-.058-x-72-dl-john-d

Oregon bar - 208RNDD024 20" chainsaw Bar 3/8 pitch 058 gauge 72 DL​

Bar Mount Pattern

Reference:​		18
Carlton:​		71
Oregon:​		D024
Windsor:​		JR/WJR
GB:​		JO
Tsumura:​
OEM:​
Comments:​		JONSERED MOUNT also used on Oleo-Mac and Olympyk

 

[Siloopy]

thanks, yes I looked already for the carlton bar 71 (but they are mostly in the US).
I also saw the prokut kit but this one is available in australia only.
I will keep looking...

I am going to restore a Dolmar 133 super and finding a bar for it will also be a challenge (mount D033 14mm gap) not many in the UK too

 

[epo]

Hi there I am rebuilding an old 264f deluxe and I am looking a bar (~ 20in 72dl 3/8 0.58) for it.
The bar mount of the 264f deluxe is D024 (10mm) and it is impossible to find this type of bar in UK.

https://www.chainsawbars.co.uk/product/jon4-20-208sfhd024-oregon-advance-cut-2050cm/

https://www.chainsawbars.co.uk/product/d4-20-208rndd033-oregon-powermatch-20″50cm/

 

[Siloopy]

https://www.chainsawbars.co.uk/product/jon4-20-208sfhd024-oregon-advance-cut-2050cm/

https://www.chainsawbars.co.uk/product/d4-20-208rndd033-oregon-powermatch-20″50cm/

great, good find!
I will have a good look later