MrTechit
New Member
Well, title says it all. I am trying to remove the flywheel.
Done so far -
1- removed pulleys
2- removed pin and thing pulley was on
3- removed the 3 big bolts that kept the flywheel on
4- put bolts into other 3 holes used to push flywheel off
5- broke backing plate that bolts push on to remove flywheel because i torqued down those bolts so much
I have heated it, splashed water on it, wd-40 and fluid filmed it, nothing makes this thing budge...
It is an older model, early 80's, flywheel has never been removed. The bearings are shot so it needs to be removed to replace them. Any ideas?
Done so far -
1- removed pulleys
2- removed pin and thing pulley was on
3- removed the 3 big bolts that kept the flywheel on
4- put bolts into other 3 holes used to push flywheel off
5- broke backing plate that bolts push on to remove flywheel because i torqued down those bolts so much
I have heated it, splashed water on it, wd-40 and fluid filmed it, nothing makes this thing budge...
It is an older model, early 80's, flywheel has never been removed. The bearings are shot so it needs to be removed to replace them. Any ideas?
