Unfortunately a bunch of saws that need to be fixed...two 372xt's, a 550, a 562, and two Stihl 441's. BUT can't get to them because of the weather doing bad things to the farm and hay..
What's on your bench
- Thread starter blsnelling
- Start date
Help Support Arborist Forum:
What a difference a few hundred miles make. We haven't had hardly any rain for quite a while, too hot here to do much work on anything. From looking at the radar it appears a big splotch of rain heading toward New York again.. I bought a pressure washer today (used), haven't had a chance to check it out yet to see what it will do...
220psi
That's what i figured you used to post daily.
We all busy now lol
Those that wants to be at least
did you get any run time on the 036 china saw you built
My china
372s are going strong no issue's.
I do my own work on everything where's the fun in mailing a saw off and taking a chance of not getting what you expected or paid for.
Someone i know i may have them cut bases or squish.
i'm not set up for it but i prefer to build my own.
Toy4xchris
ArboristSite Operative
Found this looks like it could make my buddies saw and wallet happy
http://www.hlsproparts.com/Stihl-039-MS390-overhaul-kit-with-crankshaft-p/h30391-dns.htm
Sent from my electronic leash
http://www.hlsproparts.com/Stihl-039-MS390-overhaul-kit-with-crankshaft-p/h30391-dns.htm
Sent from my electronic leash
I've built three 390s using different kits.
i used one of their kits no problem ran great i reused the oem wristpin bearing and put cabers in one but the china rings have held up fine.
Just pull a little harder!!
. That may be pretty snappy!!
Have a few tanks through the 036 and the 038 now. The 036 has a moving target for carb tuning. Have to tweak it almost every outing, and once tweaked it runs well. I really think the 038 is going to be my favorite Chinese saw. Lighter than the 066's, and with some development should run like a 70cc saw should. I like mine so far.
- Joined
- May 26, 2014
- Messages
- 20,439
You have a lot of saws! LolJust pull a little harder!!
- Joined
- May 26, 2014
- Messages
- 20,439
You always bring up good points! I never disagree with your ideas.
- Joined
- May 26, 2014
- Messages
- 20,439
I'm in the car business. Today it's so important to maintain your reputation. Nobody buys from crooked person anymore knowingly. When I buy a saw I will buy from a reputable person. We need to all be together in our business dealings.
- Joined
- May 26, 2014
- Messages
- 20,439
Do you build a lot of saws?
Just pull a little harder!!
Wish I had a few minutes today to start it lol...tomorrow I'll give her a tug
bryanr2
Addicted to ArboristSite
Tugged...fired. rocks. no wood to cut though. ..so on a shelf it goes
no wood to cut though. ..so on a shelf it goes - Joined
- May 26, 2014
- Messages
- 20,439
Nice! Who ported it?Tugged...fired. rocks.
KG441c
Keith
Couple of 064s myself and member Laslab had on the bench this morning
- Joined
- May 26, 2014
- Messages
- 20,439
Very nice job there.
