Lightly ported ms 441

[stihladdictt]

Hello everyone what’s cookin I recently ported a Ms441 very lightly ported nothing major as well as gasket delete I was wondering if a small gas puddle in the lower transfers is normal when I hold the saw to either side it revs up a bit like if it had a air leak but I checked all the seals and everything came back good this is what the puddle look like

 

[NSEric]

Did you remove a bunch of material from that area?
I wouldnt have ground on that area at all, I'd just do the far right and left sides a little bit.

I dont know squat about ms441's I mostly commented to bump this thread up.