prosawer24
New Member
hello again
basically ms362c starts up and idles very well, give it WOT for a few seconds and then the saw starts stalling/dying then it picks up power again, and so on.
whats been done to it:
brand new from STIHL fuel filter, wire harness, solenoid
replaced or cleaned parts:
air filter cleaned and tried to run without it
switched ignition coils
if anyone knows why this is happening, would be much appreciated to know!
basically ms362c starts up and idles very well, give it WOT for a few seconds and then the saw starts stalling/dying then it picks up power again, and so on.
whats been done to it:
brand new from STIHL fuel filter, wire harness, solenoid
replaced or cleaned parts:
air filter cleaned and tried to run without it
switched ignition coils
if anyone knows why this is happening, would be much appreciated to know!