Oiler propelm

[ccrain]

I recently bought a 45 husky , it does not oil right. It oils but oil never reaches chain while cutting.It all leaks down the side eventually down the side. It comes out the right spot. I am stunned. Could the pump not be putting enough out?

 

[Biggreen]

Is the oil getting to the bar groove? Bar oil hole could be plugged or misalined with oil port/possible wrong bar if you bought it used.

 

[Stihl-Pioneer]

Is the bar the correct one for the saw? Maybe the wrong mount and oil hole is not lined up.

 

[pioneerguy600]

Also possible there is no outer bar plate. Would need to see picts of the entire setup to give any serious help.

 

[wilsonishere]

Did the bar come with the saw from the factory? Have you cleaned the bar good, no debris in the chain groove? Check the oiler hole on the bar, i got a new Oregon a while back and the hole was plugged with a painted in metal shaving. Also make sure the bar is bolting up good and tight no debris on the mounting surface. If it is just a lack of oil the next step is to check the inlet fitting in the oil tank.