droback
ArboristSite Lurker
New poster here but really impressed with the knowledge so here goes.
I have a SD 112 I purchased new in 1989. Ran good all these years until now. It's been on the bench for a few months and am just getting back to it.
Saw will turn over and run for a bit - pretty rough coughing and spitting. I can rev just a bit and then it cuts out (coughing and spitting all the way).
Lots of blue smoke and muffler has built up a thin coating of oil from this.
Carb has been rebuilt with standard HK rebuild kit including regulating needle.
Any help appreciated...
I have a SD 112 I purchased new in 1989. Ran good all these years until now. It's been on the bench for a few months and am just getting back to it.
Saw will turn over and run for a bit - pretty rough coughing and spitting. I can rev just a bit and then it cuts out (coughing and spitting all the way).
Lots of blue smoke and muffler has built up a thin coating of oil from this.
Carb has been rebuilt with standard HK rebuild kit including regulating needle.
Any help appreciated...