Got My C.B 6048 up and Running with Pictures!!!
- Thread starter czar800
- Start date
Help Support Arborist Forum:
czar800
ArboristSite Guru
czar800
ArboristSite Guru
Looking good. 
rx7145
ArboristSite Guru
Looks nice! I wish my hot water heater looked that nice!
In the first pic there is a black line is that your inline fill if the water gets low?
Do you have any pics of the install on the unit itself?
Last edited:
czar800
ArboristSite Guru
Looks nice! I wish my hot water heater looked that nice!
It only looks that good because I had to buy a new one, Well my old one worked it was just on its last leg.
czar800
ArboristSite Guru
Your right it is a fill/top off line. Sorry I don't have any pictures of at the
unit, and I covered it all up real good with insulation...... Never thought to take a picture.
machinistbcb
ArboristSite Lurker
Looks great. Are those some type of compression fittings on the copper line ? Never seen any like than before.
AOD
Addicted to ArboristSite
Might wanna trim those branches away from the boiler stack, and then throw them into the boiler!
Also nice older Chevy, a great wood truck.
Also nice older Chevy, a great wood truck.
iCreek
ArboristSite Guru
Glad you finally got it ...
Looks great, congrats !!! and that pad looks awesome !!!!
My favorite pic is this one !!!! Beautiful place ...
Looks great, congrats !!! and that pad looks awesome !!!!
My favorite pic is this one !!!! Beautiful place ...
mtfallsmikey
Addicted to ArboristSite
My 5036 boiler piping...my first pic post too!..hope it works!
that is alot of pipeing in that space more so than what they show on the diagram. the thing i'm trying to figure out on ours is there is 3 outs and 3 returns 2 are large like 3/4" then the 3rd one is smaller . now on ours they have the elbow already on it . so if i can say this right first one on the top left has factory elbow on it and on the return part it's on the middle one ? so does it make a differrance whitch port the pipe is returned to?
mtfallsmikey
Addicted to ArboristSite
Top 2 on left are supplies, lower right 2 taps are returns...they are 3/4" on the '36 (??? dunno why so small). I have piped in valves/bypasses so I can purge eiether or both loops. Small blue line at bottom is makeup water...I installed the Taco isolation valves on both the circs....need to take a better pic. and, yes it is a little different than the CB diagram. As I said before, don't skimp on the valves, bypasses, etc.
czar800
ArboristSite Guru
Yes, They are a "Quick joint" Compression fitting made by the Ford Meter Box Co. You can just stab your pipe in you dont have to take the fitting apart and there good water at 240.
czar800
ArboristSite Guru
czar800
ArboristSite Guru
That in a lot going on under there, It all looks real nice, Mine is a lot simpler I only have one pump.
The Picture worked fine!
Blazin
Addicted to ArboristSite
Nice install! Your gonna love it without a doubt 
