ms460

Picked up an old 046. I checked the compression and it was at 90lbs so I recently replac d the piston/rings, coil and rebuilt the carb. It started up with some starting fluid and idled but kept bogging and dying when I tried to throttle up a bit. After about 6-7 times it stopped running all...

I need a used bar 36" and chain too if you have one. If you have pretty worn one I could get cheap that would be great. Need it to cut logs up in the river now that the water is finally dropping down. Don't want a new bar for this job

Patient is a 460, melted piston/cylinder. before disassembling top end, did a pressure test. the oil seal is leaking like an SOB, I'll replace. Also noticed that air is leaking out of this screw hole (oil pump mount screw hole, clutch side). Is this normal, the screw just plugs this leak...

Middle of last winter I picked this 460 up off of craigslist immediately after cutting wood with my buddy. Me running a pathetic MS210C and him a MS290"Farm Boss" pretty much bought the 460Mag before I dialed the number. It is a high hour saw, no doubts there. But it runs better than my daily...

Hey all, I'm in the market for a Stihl 044 or ms440. Dead or alive, it doesn't matter. A "parts saw" would be perfect. I don't really care what condition the saw is in. All I really need is a saw with a good case and a good 12mm crank. I'm hoping to find something in the southern Ontario...