huskycandoit
ArboristSite Operative
I have an old Jonsered 36 that has a 14" bar. It is 1/4" pitch. Does anyone know where I can get a bar and chain or just a bar. Cutters Choice only sells 1/4" chain but no bars.
1/4" bar and chain
- Thread starter huskycandoit
- Start date
Help Support Arborist Forum:
sedanman
Just cut the piano!!
This may be a dealer item only at this point. Even then it could be tough. 1/4 chain is getting scarce, most places only have it if they have customers into carving.
begleytree
H. sapiens moderatus
Baileys list 1/4 drive carving bars, might ask grande dog on their forum about it.
16" bar #12550
chain OR100 25AP
sprockets CSR 14
Prob easier to switch to small 3/8, IMO
Hope it helped,
-Ralph
16" bar #12550
chain OR100 25AP
sprockets CSR 14
Prob easier to switch to small 3/8, IMO
Hope it helped,
-Ralph
gatkeper1
ArboristSite Guru
oregon motor mount type A064 Windsor type FJ
I find them on ebay alot,usually sell for cheap because of being 1/4"
I find them on ebay alot,usually sell for cheap because of being 1/4"
Axeman
ArboristSite Lurker
1/4" bar
Hi; I have new 16" sprocket nose bars 1/4" pitch bars for Jonsered 36.The saw handles a 16" bar OK. We sold lots of them with 16". Also have sprockets clutch,recoil spring,gaskets.
Hi; I have new 16" sprocket nose bars 1/4" pitch bars for Jonsered 36.The saw handles a 16" bar OK. We sold lots of them with 16". Also have sprockets clutch,recoil spring,gaskets.
