346xp is now mine,

[Firewood]

Hello again Guys, so today today I went to look at the saw I had been looking advice on, small scratches and not much else cosmetically wrong with it,
Seemed very clean motor-wise, spark plug is nice and brown, piston and cylinder are brand new or as close to it, both are the hyway variety,
Starts, runs, an hot restarts at the tip of the pull cord,
Cut a small bit of Ash and pine when I got home as I was advised by the shop to take it easy for the first two tanks and yea, I can see why these are popular, the only way I can describe it is it just seems to fit, very well, now matter which way you hold it, very very well balanced, chain brake, starter, all controls tight as a drum, new bar and chain also,
Dare I say I am very happy with this,
Thanks again to those who commented with their inputs it's very much appreciated


The only issue I can find is there is a small fuel weep somewhere near the clutch side of the saw, seems common enough but I will ask now, has anyone had one of these saws and successfully fixed it and how?

If anyone needs pics of the leak/weep I can post them tomorrow or if anyone has any photo requests send them on

 

[singinwoodwackr]

Fuel leak? May need new tank vent but, track it down, specifically.
Nice clean saw!