anyone in Maryland? Looking for a few chunky slabs for chair bottoms.

[johndeereg]

I would like to find some ideal cut, about 2-3 inch thick boards to make chair bottoms out of with chiseling, carving etc. Anyone have any ideas where to find some oak?

 

[marylandgrdnr]

I would like to find some ideal cut, about 2-3 inch thick boards to make chair bottoms out of with chiseling, carving etc. Anyone have any ideas where to find some oak?

i'm in the Frederick and union bridge area

i have thick honey locust slabs.

[email protected]

 

[johndeereg]

I'll email you, thanks!

 

[Samcronkite]

I have some two inch oak that was cut about 2 years ago, or if you want something thicker I can cut you what you want.

Sam

 

[johndeereg]

just sent you a message

 

[rarefish383]

OOPS, don't know how I missed this one. Welcome to all of the new MD guys. Did you find your slabs? I'm in the Frederick area also. Oak slabs should be no problem around here. I have 2 large dead Red Oaks I'll be dropping for firewood in a week or so. Was planning on milling the bottom 7' of the log for benches, usually cut those at 3". Good luck with your project, Joe.

 

[terryknight]

I'm also in MD i have some 2" white oak slabs. and two large burr oak logs which i can cut to spec. I am on the Eastern Shore

 

[johndeereg]

I'm also in MD i have some 2" white oak slabs. and two large burr oak logs which i can cut to spec. I am on the Eastern Shore

anyone have any that are over 12" wide?

 

[terryknight]

anyone have any that are over 12" wide?

i will around the end of OCT. up too 24" wide by 8 ft long. they will be freshly cut and need to be dried.