Bar mount question

[Welderman85]

Can I run a k041 bar on a k095 mount saw. . Thank you

 

[Bob Hedgecutter]

Unaltered- no.
K041 oils through the adjuster holes of the bar- if you want to run one on a K095 mount saw you have to drill holes that line up with the oil delivery gallery.

 

[Welderman85]

Unaltered- no.
K041 oils through the adjuster holes of the bar- if you want to run one on a K095 mount saw you have to drill holes that line up with the oil delivery gallery.

What if I want a 095 bar on a 041 saw. Thank you

 

[Bob Hedgecutter]

What if I want a 095 bar on a 041 saw. Thank you

Well gee- guessing as how the oil pump of an 041 mount saw would be trying to push oil through the adjuster holes- I guess you would have to make an access way between the rails into the adjuster hole of the K095 bar.

 

[RedneckChainsawRepair]

Some K095 will on a K041 saw and some wont work without modding first. I did this other day to test this K095 bar out on a K041 saw without modding it.
It is harder and got to be careful to make sure to tilt tensioner pin into the bar hole. It also did hole fine as the K095 oil hole was still lined up with oiler area on mount. IMO it's easier to do the 5min elongated way like shown in other bar pic.

The other bars shown are how I normally do the K095 to fit and oil easier for K041 saws.

I always had to mod K041 to fit my K095 saws.