Bought this at the pawn shop today....I can cut the other way now...lol

[jockeydeuce]

I got a tip from a buddy that this was at the pawn shop. I've thought about buying one for a long time, but paying the shipping from Baileys to Canada has always held me back. Hardly looks like it's been used and has the 24" rails which is big enough for anything I'll be milling.

Just got to figure out which saw is going to get clamped in it.....:msp_thumbup:

 

[atvguns]

Looks new

 

[betterbuilt]

 

[jockeydeuce]

Looks new

I think it's literally been used once!

 

[john taliaferro]

64 with a 10 pin rim throw saw dust down here:msp_thumbup: if you take the bottom clamp bar off and drill and tap the uprite , and bar , you can change the chain in 2 min .

 

[jockeydeuce]

64 with a 10 pin rim throw saw dust down here:msp_thumbup: if you take the bottom clamp bar off and drill and tap the uprite , and bar , you can change the chain in 2 min .

Thanks for the tip on modding it for a faster chain change!

 

[jimdad07]

Great find, if you drill the bar and upper clamp you will not regret it. It's about the best way to run them. Just don't forget to bring extra nuts and bolts when you are out milling, sometimes they like to vibrate off and will screw a good slab up at the worst possible time, don't ask me how I know.

 

[thechknhwk]

So now you go both ways?