Hi guys,
i made a small/big mistake during my chainsaw repair career.
I always put generic Walbro Kits from China in all my Walbro WT and WTE carbs BUT there is the WT and WTE type specific diaphragm.
The WT can be repaired with D20-WAT which has a diaphragm pin height of about 1.8mm but the WTE type like used in the MS260 or the Dolmars require a different diaphragm with a much flatter middle pin, has nr D10-WTE which you cant get in the chinese sets it seems. I didnt pay attention to this, all saws run perfect buit i still want to make the WTE carbs perfect again.
The WT diaphragm with the high 1.8mm pin has the nr.: 95-526-9-8, does anybody have the correct one for the flatter WTE type pin which has approximately 0.6mm height?
BR and thanks a lot
i made a small/big mistake during my chainsaw repair career.
I always put generic Walbro Kits from China in all my Walbro WT and WTE carbs BUT there is the WT and WTE type specific diaphragm.
The WT can be repaired with D20-WAT which has a diaphragm pin height of about 1.8mm but the WTE type like used in the MS260 or the Dolmars require a different diaphragm with a much flatter middle pin, has nr D10-WTE which you cant get in the chinese sets it seems. I didnt pay attention to this, all saws run perfect buit i still want to make the WTE carbs perfect again.
The WT diaphragm with the high 1.8mm pin has the nr.: 95-526-9-8, does anybody have the correct one for the flatter WTE type pin which has approximately 0.6mm height?
BR and thanks a lot
