Can I go Rim sprocket on my 201t

[bruiser1]

Just was wondering 201t comes with spur but would like to go rim when it wears down?

 

[DND 9000]

There are only spur sprockets availible for the MS 201T. It is also because of the outside clutch.

 

[user 122190]

I went from a spur socket to a rim socket on my ms290. Zero, nada, no difference that I can tell.

Just was wondering 201t comes with spur but would like to go rim when it wears down?

 

[earlthegoat2]

A rim sprocket setup could be done on the saw regardless of the fact it is an outboard clutch. Husky outboards seem to handle them well enough.

But once again, I also know of no conversion available. The conversion would more than likely also include a different oil pump pinion for the new rim drive to rest into.

 

[Urbicide]

I don't think that there are any rim sprockets made for 3/8ths low-pro chain.

 

[tacomatrd98]

I don't think that there are any rim sprockets made for 3/8ths low-pro chain.

rims for 241/260/261 etc are available in 7 and 8 tooth in 3/8 lp from stihl

 

[Duane(Pa)]

The spur engages the oil pump drive helix, so you might need to rig something to make it work. I doubt it's worth the effort, but I have always put rims on saws that will accept them.

 

[Urbicide]

I found a 7-pin, standard spline, low-pro rim available from Left Coast Supplies: http://leftcoastsupplies.com/product/rim-3-8lp-x7-standard-spline-gbf-gbr7l7/
They also carry a variety of lengths of GB bars equipped with a 3/8",lo-pro sprocket nose. You learn something new every day.

 

[ironman_gq]

rims for 241/260/261 etc are available in 7 and 8 tooth in 3/8 lp from stihl

And the 170/180

 

[Cliff Baxter]

Is there any reason not to run a 325 chain on a ms201 assuming you could get the clutch conversion. I was told once by someone in the business that they put lo pro chains on climbing saws to reduce the production cost