Mastermind
Work Saw Specialist
Just making sure you ain't setting me up.
After all.......you do follow me all over the interweb trying to make me look bad and stuff.
Just making sure you ain't setting me up.
Just making sure you ain't setting me up.
Are you gonna be there John?
Yeah I'm planning on it. There's nothing better than having a good excuse for getting away from this little shop. :msp_thumbup:
Awesome! There is a guy coming to look at my truck this weekend. Hopefully he'll buy it. Then ill have the money to order my lathe.
Yeah I'm planning on it. There's nothing better than having a good excuse for getting away from this little shop. :msp_thumbup:
The Mall11 started and ran on it's own for a few minutes today. Anyone have an idea what the "initial" baseline settings should be on the carb? It does run, but not real well,at the moment.
Baseline......................1/4 to 1/2 out on the idle cicuit, one full turn on the main needle. Remember the main needle may wind up most anywhere 'cuz a lot of them have been screwed down with a screwdriver at some point and buggered the needle end AND the seat. Cleanliness in a MD or a ME is critical
Igpoe
Awesome! There is a guy coming to look at my truck this weekend. Hopefully he'll buy it. Then ill have the money to order my lathe.
Baseline......................1/4 to 1/2 out on the idle cicuit, one full turn on the main needle. Remember the main needle may wind up most anywhere 'cuz a lot of them have been screwed down with a screwdriver at some point and buggered the needle end AND the seat. Cleanliness in a MD or a ME is critical
Igpoe
Now when and where is this gathering taking place?
Nice old pioneer, there.
Now when and where is this gathering taking place?
Enter your email address to join: