Sold Clean Poulan 4400

[miller755]

Poulan 4400 I bought locally recently. It's in really nice shape. I cleaned it up. The saw will idle indefinitely, in all positions, seemed to run good and cut good with the clapped out bar and chain that were on it. It just started on the first pull after sitting since last night. This thing is healthy with 175 psi, which Is the highest I have seen on this gauge, most saws fall in the 150-170 range on this gauge. I am putting it up for trade because it is kind of too nice for me. Two minor issues, the spur is in bad shape, and the fuel line is not tight to the hole in the tank, so there can be a small amount of leakage if you turn the saw upside down. $350 plus shipping.

 

[miller755]

Pics

 

[svk]

What sort of things are you looking for in trade?

 

[ElevatorGuy]

I read that gauge at 175 lol.

 

[skkoehn22]

I have the Poulan 4900 and I cannot find parts for it anywhere. Where is a good place to get parts for these old saws. I need a new air filter but there is none available.


Sent from my iPhone using Tapatalk

 

[miller755]

I read that gauge at 175 lol.

Upon closer examination I cede your point, edited...forgive me it was after 11...

 

[miller755]

What sort of things are you looking for in trade?

Chainsaws...seriously though, I'm dreaming, but something ported would move it. Otherwise, let me know what you are willing to trade, I guess I would do cash on either end of the deal to make it fair.

 

[bmwz3coupe]

Poulan 4400 I bought locally recently. It's in really nice shape. I cleaned it up. The saw will idle indefinitely, in all positions, seemed to run good and cut good with the clapped out bar and chain that were on it. It just started on the first pull after sitting since last night. This thing is healthy with 175 psi, which Is the highest I have seen on this gauge, most saws fall in the 150-170 range on this gauge. I am putting it up for trade because it is kind of too nice for me. Two minor issues, the spur is in bad shape, and the fuel line is not tight to the hole in the tank, so there can be a small amount of leakage if you turn the saw upside down.

May I ask what fuel ratio do you use with this 4400?

 

[bmwz3coupe]

I have the Poulan 4900 and I cannot find parts for it anywhere. Where is a good place to get parts for these old saws. I need a new air filter but there is none available.


Sent from my iPhone using Tapatalk

Lookup air filter 4400 here for a simple fix. I going to do it to mine.

 

[miller755]

May I ask what fuel ratio do you use with this 4400?

I'm sure anywhere between 32 to 1 and 50 to 1 will work fine for you. Personally I mix between 32 and 40 to 1 for everything probably ends up at 36 to 1 or so.

 

[Walker hindsman]

How much would you like to get cash wise for the saw


Sent from my iPhone using Tapatalk

 

[miller755]

How much would you like to get cash wise for the saw


Sent from my iPhone using Ta

How much would you like to get cash wise for the saw


Sent from my iPhone using Tapatalk

Make me an offer

 

[miller755]

$350 Plus shipping...

 

[miller755]

Pending...