climbing and rigging

[JonnyHart]

Take small pieces that do not have to be tied and tie them to learn how they react when cut. Learn how different species of wood reacts when cut. Learn to adjust for lean and wind while cutting. While in an open area try different notches in different directions to practice.

That is awesome advice. After awhile it will be instinct. You will know exactly where a piece is going when you cut it.

 

[Tree Machine]

A power-ported 346XP with a razorsharp full-chisel chain, could be more efficient.

On mine I'm about to change out the drive sprocket, run a 14" 3/8 LP chain like on your 020, and a carving bar. I'm thinkin, THAT might be the reigning king of 'efficiency'. Should be lighter than I'm used to by a bit. It's gonna be a 'light saber'.

I'll keep two-hands on my saw, though. I find precision and control in this.

 

[ou812]

But TM, you wouldnt be a bad ass then.

 

[Tree Machine]

I'm into where JonnyHart and Dadatwins are coming from, directional responsiveness of the limb being cut.

I rig only when necessary, and I'm sure that goes for just about anybody who's done this for awhile. I just like excessive power and excessive sharpness to get that job done.

Swiftness, finesse, efficiency, economy, safety and quality all come way in front of my need to be a bad azz.