pafire
ArboristSite Operative
Hello All,
I recieved my carb rebuild kit today, after installing the kit the saw started and ran fine until it warmed up and started to backfire from the exhaust and shut down. After adjusting the idle mixture and the main fuel jets the saw will idle and accerate to wide open. When the saw runs at peak rpm for a few seconds it will backfire and shut down. The saw will restart with a couple of pulls on the starter rope. When trying to cut with this saw it doesn't seem to have the power it should. Is my problem in the carb or in the timming. (sorry for the long post)
I recieved my carb rebuild kit today, after installing the kit the saw started and ran fine until it warmed up and started to backfire from the exhaust and shut down. After adjusting the idle mixture and the main fuel jets the saw will idle and accerate to wide open. When the saw runs at peak rpm for a few seconds it will backfire and shut down. The saw will restart with a couple of pulls on the starter rope. When trying to cut with this saw it doesn't seem to have the power it should. Is my problem in the carb or in the timming. (sorry for the long post)
