So I put the dogs from the pool on 295 on my 2550, and I like the way it cuts, but the screws work loose with vibration.
I have a bottle of blue Loctite, and I would imagine that’s sufficient to keep the screws from backing out. I don’t want to over tighten them and strip the holes.
Any advice before I proceed? Will Loctite stick to the insides of plastic holes that have been exposed to bar oil over the years if the holes are cleaned out first with a toothpick and then with carb cleanser first then rubbing alcohol?
I have a bottle of blue Loctite, and I would imagine that’s sufficient to keep the screws from backing out. I don’t want to over tighten them and strip the holes.
Any advice before I proceed? Will Loctite stick to the insides of plastic holes that have been exposed to bar oil over the years if the holes are cleaned out first with a toothpick and then with carb cleanser first then rubbing alcohol?
