Want to Buy Dolmar 166 piston

[jonsered raket]

Need a 166 piston, doesn't have to be perfect. Let me know what ya need for it thanks!

Sent from my N9100 using Tapatalk

 

[sawfun]

I have a used Weisco piston with pin. The piston has a few minor scratches but would be fine to run. $75 + shipping

 

[RedneckChainsawRepair]

OP If it is the run of wiseco 166 pistons Lee had made up grab it. I had a couple of these I bought from Lee new.

 

[sawfun]

Yes its a Lee piston that was in a saw that the rod and bearing went bad in.

 

[jonsered raket]

Saw fun I started a convo

Sent from my N9100 using Tapatalk

 

[leeha]

Yes i sold that piston to sawfun, The Wiseco pistons i had made
and have used a few with no issues at all. 75.00 is a great deal
and less than half the cost if it's a good piston.
Make sure you use the wrist pin bearing that comes with the piston.


Lee

 

[jonsered raket]

Will do Lee, its actually for a 111 hot saw.

Sent from my N9100 using Tapatalk

 

[leeha]

I had these set up for .0045 thou clearance and have had no problems what so ever.
Haven't had any complaints with the ones iv'e sold. These pistons will also take more
heat than an oem piston. Your hot saw may require a little more clearance. Thats up
to you. Good luck with your hot saw.

Lee

 

[jonsered raket]

Lee do you still have more pistons for sale?

Sent from my N9100 using Tapatalk

 

[Jacob J.]

Lee do you still have more pistons for sale?

Sent from my N9100 using Tapatalk

Good question...I wouldn't mind having one of those.

 

[sawfun]

Piston sent and received, awaiting response.

 

[jonsered raket]

Pm sent sawfun

Sent from my N9100 using Tapatalk

 

[leeha]

I have a couple i can let go.