funky 365

[bz262]

i had to replace mounts on my 365 today (i broke 2 of 'em in one day. can you believe it?) anyway, now my saw only wants to run at half throttle. it starts and idles fine, but when i hold it wide open, it only runs and cuts at about half speed. i changed the mount under the on/off switch and the one between the cylinder and wrap around handle, but i didn't take off the gas tank completely. any ideas

 

[RiverRat2]

was it cutting fine before u changed mounts????Are you talikg about the Steel springs???? any way pull the air filter and filter mount so you can look in the throat of the carb, Then with choke open make sure the throttle plate on the carb is opening fully @ WOT then report your findings......

 

[bz262]

yup, the springs.

will check the carb

thnx