samaritan
ArboristSite Operative
After pulling my hair out trying o get this saw to run, I think I found the problem. It is hard to prime, the button is stiff when pressed, even though its new, and the return line will not allow air to pass thru it. I accidently discovered the vent plug between the handle and tank on the right side, so I replaced it, and now air will pass thru return line to tank, so I will soon know if this solved the run and stall issue, once I get the grommet on the fuel feed line installed (leaking around opening where line goes into tank). I saw on you tube that a few guys replaced or cleaned he plug, or in my case he steel rod that is installed in a hole under the pull start cover on rt side. I will post my result soon.
