Husky 455 Rancher dies

[saxon]

The saw will crank good and run good for about 1 minute then will just quit running.
The L is set at 1.5 turns out and H is 1.25
What is the problem?

 

[irhunter]

run good for about 1 minute

It cuts wood, like before, for that minute?

What do you use for gas/oil? How long do you let gas sit in the saw?

How old is the saw?

Roy

 

[saxon]

I dont make it to the wood before it dies
93 octane pure gas/husky oil 50:1 I had been running the saw previously, so fuel is fresh
around 7 years old

 

[Marley5]

Start simple.
Clean air filter ? Clean fuel filter ? Clean spark arrestor screen ?
Will it sit and idle for several minutes ?
Had 2 of them over the years and were great firewood saws.

 

[Herbert Schwarz]

Is the spark plug dry when it is dead?

 

[irhunter]

In addition to the two previous posts (Herbert and Marley), I will add:

It is generally a bad idea to buy parts before knowing what the problem is. But, if you have never replaced the fuel filter...I would do that now, and just call it "routine maintenance". And, a new spark plug now, would be a good idea.

I second: good homeowner saws.

Roy

 

[coffeebrk]

I'd start with a carb kit and see what happens. If you can pressure test the fuel line, great. As mentioned it's time for a fuel filter

 

[ChillyB]

Started happening to my 350 a few years ago. Fuel line decayed in the gap between tank and the clamshell. Was sucking air.

 

[irhunter]

I have a 445 which is two-times older than the saw in question...it has cut a lot of wood without anything more than one fuel filter...replaced just as maintenance.

My WAG is not fuel line or carb. Emphasis on "guess."