Husqvarna 120 mark ll

[mad_mat222]

Greetings,
Have a mark ll and the easy start spring keeps binding up. I replaced one pulled three times drop starting (I know you shouldn’t) damaged, replaced and pulled very gently just turning it over, damaged. The engines fine and turns over easily. There’s no obvious damage.

Is the a mod to delete that spring. It’s a rubbish design. Any advice much appreciated.

 

[irhunter]

I would go to Beg for Manuals thread and ask for an IPL for that saw. Probably, the parts you need for conversion are shown there.

Are the replacement parts you're using OEM?

Roy

 

[mad_mat222]

There are no mods that I’m aware of and the springs are genuine.

 

[NSEric]

On a bunch of the chinese saws you can screw or silicone the assist spring into place so it doesnt move then you have a regular pull start.
I havent seen a 120 mark II so I dont know if it's the same set up or not.

 

[mad_mat222]

It’s a gimmick they should piss off. I might start look into sourcing. Solid pulley from another model. Perhaps the earliest ones fit.

 

[ray benson]

Greetings,
Have a mark ll and the easy start spring keeps binding up. I replaced one pulled three times drop starting (I know you shouldn’t) damaged, replaced and pulled very gently just turning it over, damaged. The engines fine and turns over easily. There’s no obvious damage.

Is the a mod to delete that spring. It’s a rubbish design. Any advice much appreciated.

I see 2 ipls

 

[mad_mat222]

Thanks for that. I have looked at those already. Interestingly they do not include the break down for the start assist. Part 545008028 seems to be a solid one piece pulley. I had ordered another similar one with a different part number already but look identical so will see if I’m heading down the right track.

 

[mad_mat222]

So have the part number for the swap. Change out the pulley and retaining screw. You can get away with using the original screw but it requires a shim.

Hope that saves time of stuffing around with damaged springs.

 

[doopy]

So have the part number for the swap. Change out the pulley and retaining screw. You can get away with using the original screw but it requires a shim.

Hope that saves time of stuffing around with damaged springs.

I'm having the same issue seems like the spring in digging into the plastic wer it seats on the shaft. orderd parts from husqvarna sent a pic of the pully and spring 3 pc design 2 weeks lator got delivered wrong part. went on web sit talked to someone else sent more pic. he's like that's the easy start so thear sending out another pully. Will see in2 weeks. wondering if i can use the first pully thay sent it's a 1 pc solid design . thay said don't send it back. may look at that today been 5 degs hear in ky hard to get an old man out in that lol