Want to Sell Husqvarna 375xp - ported Dustin Wilt

[04titanse]

Have a super clean, super sweet saw!

Its an all OEM parts built by dustin wilt. 75cc ported top end build ( all new parts, jug, pistom bearing etc etc), all new bottom end parts, power coated cases, low top, big dogs, ported oem muffler, full wrap, large clutch cover etc etc. This was an expensive built

VERY low hour saw. 5-6 tanks through it. Nearly flawless in all ways.

Asking $900 shipped OBO PHO

 

[HumBurner]

Wish I could justify that. I'd have to sell my 71cc x-torque!

 

[TLG]

Dustin does a great job on this series.

 

[Jusgunn3]

Beauty!

 

[dustinwilt68]

I remember building this saw, it was all oem parts used on it, be hard to find another like it

 

[HumBurner]

I remember building this saw, it was all oem parts used on it, be hard to find another like it

How many of these did you build?

 

[dustinwilt68]

How many of these did you build?

Probably 12 in total, the cylinder kits became NLA

 

[Jusgunn3]

How do these compare to a ported 372xp? More low end I’d imagine.

 

[dustinwilt68]

How do these compare to a ported 372xp? More low end I’d imagine.

Little more all over, but they do have more bottom end also

 

[bwalker]

Little more all over, but they do have more bottom end also

Do you have to do alot of work to the smaller transfers on the 75cc cylinder vs the larger transfer 71cc cylinder?

 

[dustinwilt68]

Do you have to do alot of work to the smaller transfers on the 75cc cylinder vs the larger transfer 71cc cylinder?

They definitely require more work to get them right then a OE 71cc cylinder

 

[04titanse]

TTT

 

[gavinmalloy18]

Any trades?

 

[04titanse]

Any trades?

No thanks, trying to thin out my saws a bit.

But thanks!

 

[04titanse]

.

 

[singinwoodwackr]

A tempting replacement for my 372…

 

[david newbie]

A tempting replacement for my 372…

Just get it. You need more saws

 

[Jusgunn3]

if I can sell my 572xp I might throw an offer in!

 

[Meadow Beaver]

Silver crankcase is pretty cool