Picked up this nice old Montgomery wards chainsaw yesterday. From what I can tell it looks like a rebranded Remington PL4. I believe it’s 59cc and it has a 17” bar on it.
Pulled the muffler at the guys house just to make sure it was alright. Piston and cylinder looked good. Got it home and checked the vitals. Has spark and about 120-125psi compression. Should run with a carb rebuild. Fuel tank looks clean. Fuel lines and filter look alright too.
Cleaned it up good and ordered a carb kit for it (tillotson hs82a carb). Hope to get it running soon. Will need a chain too if I decide to cut with it.
Pulled the muffler at the guys house just to make sure it was alright. Piston and cylinder looked good. Got it home and checked the vitals. Has spark and about 120-125psi compression. Should run with a carb rebuild. Fuel tank looks clean. Fuel lines and filter look alright too.
Cleaned it up good and ordered a carb kit for it (tillotson hs82a carb). Hope to get it running soon. Will need a chain too if I decide to cut with it.
