MS361 Idle Question

[StihlsawuserMS361]

I'm the original owner of a MS361,probably from 2009 or so. Saw has been used but not abused, primarily used for firewood bucking. Last year I noticed the curb idle would change, whereas I had to either increase or decrease idle speed, something I've never had to do previously. Always E Free fuel, Stihl Ultra oil. I'm thinking maybe an air leak. I'm smart enough to do a pressure/ vacuum test but haven't purchased the needed tools. I believe instead of messing with a saw that only had an oil pump replacement (my fault, leaving tape on the discharge hole while cleaning, causing the saw to over oil) since I've owned it, I'd prefer to have someone better skilled to say repair or reseal it.
Can anyone recommend a reputable shop somewhere near the 13905 NY area for this service? Or to ship it out maybe? What's left of the Stihl dealers locally aren't skilled enough to do much of anything. The saw still runs and cuts great, I'd rather address this before I have to.
Thanks to all.

 

[Wood Doctor]

Rather than an air leak, it might just need a new carburetor. It's a rather simple installation for an average mechanic. Worth fixing in my book, I have changed out several. Start with an AM carb (less than $20 on e-bay) and see if that solves the problem. If it does you can then feel better about spending three times that much on an OEM carb. Replacing this saw with a new one would set you back about $800 or so. Good Luck!

 

[StihlsawuserMS361]

Thanks Wood Dr.
I guess I've overlooked the basic carb scenario by reading most here saying vac/leak check. I'm certainly capable of replacing, but with this saws condition, I think I'd prefer OEM or even a carb kit

 

[irhunter]

The way you treat the saw--really well--it shouldn't need either seals or a carb kit.

But, it probably does.

It stinks that full-service Stihl dealers can't all be relied on to do something simple like this.

But, they can't.

So, if no one comes along with a suggested repair shop...you'll probably need to just buy the p/v tester or do a carb kit.

I'd suggest the former, as you'd like to pressure test the carb if you get around to rebuilding it...and, you need a pressure tester for that.

Roy

 

[Wood Doctor]

Thanks Wood Dr.
I guess I've overlooked the basic carb scenario by reading most here saying vac/leak check. I'm certainly capable of replacing, but with this saws condition, I think I'd prefer OEM or even a carb kit

One other thing that is worth trying first. Check the final screen filter inside the carb. It may be clogged enough to mess up the idle. Part #26 below:

These clog up and need to be cleaned (or replaced) every few years or so. They sometimes show up in rebuild kits. But, usually a simple clean up is all you need to do.

 

[slowcar281]

I would go ahead and invest in a mity vac, they are really good to own. There are block off kits for the intake and exhaust that you can buy for cheap, or make your own.

Does the saw drastically change idle if you turn it on its side? Sometimes that can be indicative of an air leak, typically crank seals.

You can try cleaning the carb, and putting a kit in it. If that doesn’t work I’d highly recommend an OE carb.

If you were closer I’d gladly pressure test the saw and install crank seals if needed