ms660 oem tank.
repair hole from a screw that went through the tank from the pto side handle bar.
its a clear circular screw hole, otherwise tank is good.
thinking about different repair techniques for this one...
(1) just melt down that hole from the inside
(2) put some plastic in screw hole and proceed with option1 again
(3) fill hole with seal all
(4) fill hole completely and screw hole with jb weld until flush with outside and drill away
(5) cover longer screw with ptfe tape and seal all and once put in never remove screw permanently (dont like this option)
i think gas tank is pa66 i have other parts stihl gas tanks i can take bits of plastic from i guess...but im not sure what other plastic has pa66 that will melt nicely to fill hole
repair hole from a screw that went through the tank from the pto side handle bar.
its a clear circular screw hole, otherwise tank is good.
thinking about different repair techniques for this one...
(1) just melt down that hole from the inside
(2) put some plastic in screw hole and proceed with option1 again
(3) fill hole with seal all
(4) fill hole completely and screw hole with jb weld until flush with outside and drill away
(5) cover longer screw with ptfe tape and seal all and once put in never remove screw permanently (dont like this option)
i think gas tank is pa66 i have other parts stihl gas tanks i can take bits of plastic from i guess...but im not sure what other plastic has pa66 that will melt nicely to fill hole