Yes on bearing and about. 007 to .012 more or less. Never read the real dimensions. Mine are .040 below the face
Nik's Poulan Thread
- Thread starter FATGUY
- Start date
Help Support Arborist Forum:
jerry quinn
Proud dad of a US Marine.
thanks again.
My old racesaw is now famous. It got a modeling job for Cliff and Rick Helsel.
There is one give away on it to tell it is my old saw.
There is one give away on it to tell it is my old saw.
redunshee
Addicted to ArboristSite
I've never been concerned about end play on my Countervibes. Radial play on the other hand means bearings might be bad. I believe end play is a function of both the bearing position and thrust washer.
Mine was bad the bearing had walked outwards and the washer was a bit chewed up and was chewing into the case only on the flywheel side. The advice from you good gentlemen here saved that saw from certain death.
You were a good student and there was some great teachers that came up with the best advice as to how to fix it. That was the first time a lot of us had heard of making rings from the 7700. Well done
Well thanks Todd if I take care of it it'll last me many many years just doing a bit of firewood here n there. Its starting ok now not amazing but ok after a week of sitting it will fire on the 3rd of forth pull and be running by around yank number 5
Sounds about right when they sit awhile. Try a top handle Poulan when they sit for a few weeks, you will pull more than 4 or 5 times, I can tell you that.
Steve
Steve
Anybody use Tapatalk, if so, what's the kin stuff about?
Steve
Steve
Do you use the throttle lock?
Must use the throttle lock for sure on a cold start.
Steve
Steve
Yup throttle lock for sure
Mmmm, may need starting fluid. [emoji6]
Steve
Steve
Ewwww
If you haven't already, try messing around by richening up the idle mix screw. Perhaps that should be enrichen.
Mite give that a wee go next time
Anyone know the bearing number of the midget sized needle bearing pair used in the 3400-4000 pistons? Probably were made by Torrington, or Koyo.
They're not listed separately on the IPL as they are already pressed in with the piston assembly.
They're not listed separately on the IPL as they are already pressed in with the piston assembly.
Not sure but flebay has a set under poulan 3400
Anyone have a piston pin out of a 4200 -8500 size motor, found a piston but no wrist pin
Torrington B 66 or
INA S 66 3400 brg
INA S 66 3400 brg
