Nik's Poulan Thread

[heimannm]

I have a good supply of 0.006" thick material if that will work.

Mark

 

[RedneckChainsawRepair]

Thanks for the heads up, I think I'm going to hold out for a 3750 though. I want that color scheme and decals to go with my Wild Things.

I'm in a chainsaw repair group on Facebook, it might be yours.

Did you get that 3750 TA BB there? I seen you in thread and has been marked SOLD now.

 

[Todd Loosli]

I used to have a few extra but I'm out of any that I could sell.

 

[Gunsling3r1988]

Did you get that 3750 TA BB there? I seen you in thread and has been marked SOLD now.

No, I don't have PayPal or any of those ways to pay so I need to find one in driving distance if possible.

 

[RedneckChainsawRepair]

Just had a box of mine found on highway where it fell out of the back of USPS semi with doors open.
In Alabama last week.

Cop found it contacted address and ask if theirs and whats in it. He says chainsaw.

Cop opens to confirm and takes to USPS P.O. in town for guy to go pick up.

Lady at counter ask him whats up with all the water bottles. Duh! SMH

In case idiots drop out of back of semis doing 70 down the highway.

 

[Snowchaser]

I have a good supply of 0.006" thick material if that will work.

Mark

Mark, i contacted American Rubber Products and they sent me a 12x12 square of nitrile nylon .006”. It is the perfect thickness. I am working on seeing if my daughters laser cutter can cut this material without burning or shrinking it. If so, then i can draw up the diaphragm and cut lots of them. I hand cut out one for my 4000 and it works great too. I’ll let you know what i find out. If you wanted to send some material, i would be happy to make you some.

 

[Gunsling3r1988]

A pic of the old Poulan 25DA I bought last year. It runs but not great, need to get the carburetor adjusted on it so I can use it more. Does anyone know how high these should rev? Online I saw 8500, I'm afraid this one is too lean after checking it on my tach the other day and it went over 10k rpm.

 

[Big Dan]

I think it's supposed to be 8500 while in in the cut but not positive,10k sounds high to me . You might check the sparkplug, if it's white or gray it's too lean. Should be a chocolate brown.

 

[Big Dan]

I haven't ran my s25cva for awhile but I'll fire it up and check it with a tach tomorrow.

 

[heimannm]

I am looking for a starter housing for a PP Super 380, or any other alternative that would work on that chassis. Customer says the PN is 530049938, looks like I missed a couple on eBay recently.

What are my other options?

Mark

 

[Gunsling3r1988]

I think it's supposed to be 8500 while in in the cut but not positive,10k sounds high to me . You might check the sparkplug, if it's white or gray it's too lean. Should be a chocolate brown.

It wasn't in the cut when it revved that high.