Oldie but a goodie. Pioneer 1074

[Saiso]

Hi folks! It has been a while since I posted but I expect to be back regularly in a month or so.

So I was finally able to find my first « barn find » through my wife’s family. Someone passed away so I was able to hit the jackpot. Two old snowmobiles (87 citation, 94 jag), 5x8 dump trailer, 33in snowblower, ride on mower, push mower, trailer for 4 wheeler, air compressor, etc etc.
Ok ok I’m rambling. This thread is about the Pioneer 1074 that I acquired too. I’m very pleased to say that it starts and sounds amazing. I’m eventually going to get to the carb getting cleaned but my priority is to replace the air filter cover and the rear handle assembly to become my first actual show piece chainsaw. We have purchased a house and are moving in September 1st and I’m stoked to display it in my 16x16 shop.

So, I can find a bit of information on the filter cover however the rear handle assembly I’m having trouble. Would anyone have an idea as to where to start for an east coast Canadian?

Pictures attached shows the filter cover and the rear handle assembly. I also assume there’s a crack underneath hence the clear patch?

Thank you !!

 

[svk]

Very nice specimen, looks to have low hours.

 

[Howsitgoineh]

That saw is in great shape. Very nice find. I have a P 21 parts saw I could sell to you or sever the handle if that helps. Good luck with your build!