pioneer roller nose bar
- Thread starter dieseldod
- Start date
Help Support Arborist Forum:
.. what bar will this fit only pioneers? bar is marked pioneer 47425 them possibly a 7 followed by more unreadable digits.
I had that one those bars and made it work for small mount husky by drilling oiler holes etc as needed.
Maybe mine was different somewhat. I had to drill the 2 tensioner holes and oiler holes. Worked great on small husky mounts for me.
Had pioneer 2071 wrote on it when I got it.
Old post on it = That made in Canada Pioneer bar has some tough steel in it. I drilled for a hour and a half with hardened bits ( courtesy of Al Smith) to drill 2 bar adjuster holes and 2 more oiler holes so the bar would work on small husky mount saws with 60dl chain.
Rollertip has Pioneer grease daily around tip.
Bar area has 473394
16 050
10 0
Pioneer
made in canada
Had pioneer 2071 wrote on it when I got it.
Old post on it = That made in Canada Pioneer bar has some tough steel in it. I drilled for a hour and a half with hardened bits ( courtesy of Al Smith) to drill 2 bar adjuster holes and 2 more oiler holes so the bar would work on small husky mount saws with 60dl chain.
Rollertip has Pioneer grease daily around tip.
Bar area has 473394
16 050
10 0
Pioneer
made in canada
Attachments
Pioneer bars were sort of their own thing, I have modified other makers bars to fit Pioneer saws but not the other way round, seems more work that what its worth as it seems easy to find bars that fit most other makers saws unless its one of those rare saws that no other bar comes close to fitting. When one becomes desperate there are no lengths too far to go adapting a bar, back end can be completely cut off and all new slots, adjuster and oiling holes redrilled, just depends on how much time one wants to put into it. I have McCulloch bars on some of my Pioneer saws.
dieseldod
ArboristSite Operative
thats great thanks,, i have a pioneer with a good bar ,i,ll keep them together. my bar has all the same markings as yours just the last 4 digits are different. certainly dont plan drilling that quality steel , thats hard work! thanks
