Want to Sell PORTED MS441CM-R

[ELECT6845]

This saw was built back in the summer following Randy's build thread. I made a few changes with how the cylinder was cut for some added compression. The port timing numbers are close to what Randy uses and this saw runs fantastic. Compression is 205 and it pulls a 25" bar buried with no problems at all.

Saw has been used and as you can see the clutch cover has a piece missing on the top. Bottom of the saw has fading and scratches. Handle bar is missing some paint.

ASKING 725.00 shipped to the lower 48

 

[groundup]

Is it a R model? I noticed it does not have the larger clutch cover

 

[ELECT6845]

I bought it used and took it as the R model since it had the wrap handle. I could be wrong

 

[XSKIER]

Not likely an R. It has the regular chain catch that is not installed on an R. The dawgs look a little too big too, but maybe because of the standard clutch cover. High output T oiler? Soft AV springs?

 

[ELECT6845]

Not likely an R. It has the regular chain catch that is not installed on an R. The dawgs look a little too big too, but maybe because of the standard clutch cover. High output T oiler? Soft AV springs?

So you think its just a 441c with a wrap handle?

 

[groundup]

Yeah based on the clutch cover I assumed it is a regular model. Does the oiler adjust have the notch in it?

 

[XSKIER]

So you think its just a 441c with a wrap handle?

Maybe, not really enough info to know for sure. Why don't you just send me the MS 441 ? C-M, so that I can verify all of the parts, and then accurately describe it in a trading post thread? I only charge a 10% seller's premium.

 

[SAWMIKAZE]

If its an R model i want a crack at it..i dont think it is though.. aside from the clutch cover , the chain catch kinda gives it away that its not

 

[ELECT6845]

So its not an R model but it has the wrap handle and is a C model
price reduced to 650.00 shipped

 

[mdavlee]

Mod the oiler in a few minutes and be as good or better than the HO oiler if that's a deal breaker for some.

 

[redfin]

I just dida 660 oiler last night. Took every bit of 30 minutes. Thanks Mike.

 

[windthrown]

Not likely an R. It has the regular chain catch that is not installed on an R. The dawgs look a little too big too, but maybe because of the standard clutch cover. High output T oiler? Soft AV springs?

All US model 441s after the first year have the stiffer Z rated springs. 441R model is the standard saw with the added larger side cover, dual dawgs and roller, 3/4 wrap and HO oil pump. The oil pump can be upgraded with a new R model oil pump piston and control bolt from the IPL.