Ethanol Free gas

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Im with you on this!
I just use the Puregas app and use non ethanol in all small engines I own.
I am an intermittent user of my saw. I have never had a fuel-related problem even though the saw often sits idle for up to 6 months sometimes. But I would still prefer E0 when I can get it.
If you’re using ethanol fuel you will have issues sooner or later. There is an app … Puregas that is very useful.
 
I've used regular fuel for years without much problem. One mower we have is over 30yrs old, gets regular unleaded and runs fine. I think it's more hype to use non ethanol gas than anything and you are wasting your money.
Boy will I get attacked for this.
I’m sure a lot depends on machine manufacturer and how long fuels stands before it’s used. I know it screws up everything Stihl that I own. Puregas app is very helpful.
 
I've ran stuff dry and left the float bowls full. I have heard guys say running stuff dry kills rubber parts. I can't say if that's true or not.
I run my generator only when we loose power so I use regular pump high octane fuel. When power is restored I drain the tank, then run it dry.

After it quits I put a pint or so of race fuel in the tank, and restart it, then let it run for a few minutes. That leave a little in the sump, fuel line and carb.

I don't leave any carb dry to avoid drying out the rubber that you mentioned above. Those precautions give me a one pull start next time I need it.

I've been using the same machine for 3 decades with no problems or repairs other than a fuel pump, it works for me.
 

Latest posts

Back
Top