Hello friends,
I just purchased a replacement engine for my Huskee 22 ton splitter (Briggs and Stratton 1000 Professional Series, Single Cylinder, Air Cooled, 4-Cycle Gas Engine, 25 mm x 3-5/32 in Crankshaft).
The engine arrived and to my surprise, there are absolutely no engine controls:
No on/off switch, choke, throttle speed... not even a flywheel brake. Just a red wire dangling.
Hopefully someone out there with more wisdom than me can generously share ideas for making this work on a logsplitter setup. Thanks!
I just purchased a replacement engine for my Huskee 22 ton splitter (Briggs and Stratton 1000 Professional Series, Single Cylinder, Air Cooled, 4-Cycle Gas Engine, 25 mm x 3-5/32 in Crankshaft).
The engine arrived and to my surprise, there are absolutely no engine controls:
No on/off switch, choke, throttle speed... not even a flywheel brake. Just a red wire dangling.
Hopefully someone out there with more wisdom than me can generously share ideas for making this work on a logsplitter setup. Thanks!
