jensen 32000
ArboristSite Operative
Aside from the difference in wrist pin sizes,Will any 044 piston fit any cylinder? (assuming either one is not worn out) Or do they have number or letters to match them? Thank You Mike.
Stihl 044 piston/cylinder question
- Thread starter jensen 32000
- Start date
Help Support Arborist Forum:
thompson1600
ArboristSite Guru
there will be a letter stamped in the top of the cylinder, on a round piece at the very top. You can then match the piston to that. Most will be either A or B and the pistons are usually A and B compatible, but they are also stamped on the top. There are other sizes but not very common, around here anyway.
Tom
Tom
pistons
The A or B piston has pretty much went by the wayside. I would be more concerned with fit in the bore. Yes, other than pin size, the bores are the same in an 044.
HOWEVER, at some point ( think this started with the 440), the piston ring location pins were moved outward. This would pose a problem with an old piston (044) in a 440. I know, they should not come out, but the piston ring ends would be exposed.
The A or B piston has pretty much went by the wayside. I would be more concerned with fit in the bore. Yes, other than pin size, the bores are the same in an 044.
HOWEVER, at some point ( think this started with the 440), the piston ring location pins were moved outward. This would pose a problem with an old piston (044) in a 440. I know, they should not come out, but the piston ring ends would be exposed.
jensen 32000
ArboristSite Operative
Piston ring pins
I don't quite follow what the pins moved outwards means exactly. While we are at it, Any actual measurments in mm or easy way to check for acceptable wear on the piston/skirts or the cylinders. Thank You Mike.
I don't quite follow what the pins moved outwards means exactly. While we are at it, Any actual measurments in mm or easy way to check for acceptable wear on the piston/skirts or the cylinders. Thank You Mike.
