Stihl ms361 crankcase tube

[Mike Amato]

I have a ms361 there is a hose off the crank and I can’t remember where the other end attached,??? Any help??

 

[ironman_gq]

impulse line, should go to a nipple on the carburetor

 

[Mike Amato]

impulse line, should go to a nipple on the carburetor

Ok I didn’t see one just fuel line but will look thank you very much

 

[huskihl]

It goes up to the intake boot

 

[PV Hiker]

Ok I didn’t see one just fuel line but will look thank you very much

It goes up to the intake boot

To add, with a flashlight look from the clutch side of the saw down the backside of the cylinder. Look left where the intake boot is and find the nipple for the hose to connect on the housing, not on the boot itself.

 

[huskihl]

To add, with a flashlight look from the clutch side of the saw down the backside of the cylinder. Look left where the intake boot is and find the nipple for the hose to connect on the housing, not on the boot itself.

I figured I’d get him close lol

 

[Mike Amato]

Ok I didn’t see one just fuel line but will look thank you very much

After looking at the carburetor I can only find one spot for fuel intake. Where will the impulse line connect?

 

[Mike Amato]

It goes up to the intake boot

Ok thank you. I took it apart a few months ago and couldn’t remember where it went.

 

[Mike Amato]

To add, with a flashlight look from the clutch side of the saw down the backside of the cylinder. Look left where the intake boot is and find the nipple for the hose to connect on the housing, not on the boot itself.

Ok I’ll look thank you

 

[BranchManagr]

Shill / STIHL MS361 crank tube ​

 

[pioneerguy600]

Shill / STIHL MS361 crank tube ​

Fixed for future reference.

 

[Mike Amato]

I figured I’d get him close lol

Close is good enough lol I will check this weekend and let you know guys thanks for your help

 

[Mike Amato]

Close is good enough lol I will check this weekend and let you know guys thanks for your help

Thanks everyone I found it. Replaced the crack seals. Put it all back together and now running great. Thanks again for all your help

 

[a. palmer jr.]

Mine pulled off a time or two, seems like the 361 has rather soft anti-vibe mounts and unless you use a fairly new impulse hose they tend to pull off..

 

[Mike Amato]

Mine pulled off a time or two, seems like the 361 has rather soft anti-vibe mounts and unless you use a fairly new impulse hose they tend to pull off..

Thank you for the reply
I had taken it apart a month or so to do crank seals. When I went to put it back together I couldn’t remember where it went. All set now thanks to everyone on this forum.